HyloBond M5101 Two component acrylic structural adhesive 400ml

HYLO®BOND M5101 is a toughened, two component acrylic adhesive designed for bonding a wide range of substrates.

This structural methacrylate adhesive has superior peel, shear and compressive properties. HYLO®BOND 5101 displays high toughness and can be used on gaps up to 15mm. it has a gel time of approximately 5 minutes. The adhesive has excellent fatigue and weathering resistance.

Mix ratio 10:1, cured tensile strength 16 N/mm², Volume: 400 ml

Recommended substrates

• Metals – aluminum, stainless steel, carbon steel, powder coated metals
• Plastics – acrylic, ABS, PVC
• COMPOSITES Urethane, vinyl ester, polyester, carbon fiber, FRP / GRP

Not suitable for : polyethylene, PTFE, nylon, galvanized metals, polypropylene.

INSTRUCTIONS FOR USE

The surface to be bonded can have a great impact on the cured properties of Hylobond. Care must be taken to ensure that all traces of oil, grease and dirt are removed from the substrate. This can be done with a degreasing agent or solvent such as acetone. Abrading or etching the surface can greatly improve the properties of the bonded joint, if this is done a second degreasing process is highly recommended.

Prior to dispensing it is important to extrude the product onto a non-bonding surface to ensure that bead coming out of the nozzle is a uniform grey colour. As soon as the bead is the correct colour the product should be used immediately to prevent curing in the nozzle. Enough adhesive should be used to fill the bond gap before the parts are joined. Once the substrates are joined sufficient pressure should be applied (e.g. by clamping) to avoid dry bonding and prevent movement in the joint. These processes must be completed before the geltime expires.

The optimal application temperature is about 20°C, the geltime and cure time will be affected at temperatures much higher or lower than this. The viscosity is also affected by temperature so to ensure a consistent extrusion rate and geltime the temperature should be kept constant.

Technical specifications

Label elements
Labeling according to Regulation (EC) No. 1272/2008 as amended
Contains: dibenzoyl peroxide, dibutyl maleate, rosin, methacrylic acid, methyl methacrylate,
propylidynetrimethanol, ethoxylated, esters with acrylic acid
Hazard pictograms

Signal word Danger
Hazard statements
H411 Toxic to aquatic life with long lasting effects.
H225 Highly flammable liquid and vapor.
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H335 May cause respiratory irritation.
H318 Causes serious eye damage.
Precautionary statements
Prevention
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources.
No smoking.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P260 Do not breathe fumes.
P273 Avoid release to the environment.
Response
P303 + P361 + P353 IF ON SKIN (or hair): Remove / take off immediately all contaminated clothing. Rinse skin with water/shower.
Storage None.
Disposal
P501 Dispose of contents/container in accordance with local/regional/national/international regulations.
Additional information on the label: None.
2.3. Other hazards
This mixture does not contain any substances assessed as vPvB / PBT according to Regulation (EC) No.
1907/2006, Annex XIII.

HYLOMAR GMBH, Talstraße 106, 41516 Grevenbroich, GERMANY, +49 2182 5708971, [email protected], www.hylomar.com/de