Perma Flex M125 Lubricant dispenser with Microlube GB 0

Perma Flex M125 Lubricant dispenser with Microlube GB 0 | N° 107175

Klüber Microlube GB 0 Universal high-performance lubricant

• High pressure absorption capacity
• Good wear protection
• Good anticorrosion behaviour
• Pumpable through centralized systems

Technical specifications

• Texture: homogeneous
•  Color space: red
•  Appearance: transparent
•  Density at 20 °C: approx. 0.90 g/cm³
•  Worked penetration, DIN ISO 2137, 25 °C, lower limit value: 355 x 0.1 mm
•  Worked penetration, DIN ISO 2137, 25 °C, upper limit value: 385 x 0.1 mm
•  Base oil viscosity at 40 °C, calculated value: approx. 590 mm²/s
•  Base oil viscosity at 100 °C, calculated value: approx. 31.5 mm²/s
•  Shear viscosity at 25 °C, shear rate 300 s-1; equipment:rotational viscometer: approx. 3 000 mPas
•  Drop point, DIN ISO 2176, IP 396: > 180 °C
•  Flow pressure of lubricating greases, DIN 51805, test temperature: -25 °C: < 1 400 mbar

Applications

• MICROLUBE GB 0 was especially developed for friction points subject to high loads and mixed friction conditions. It is a universal grease suitable for the lubrication of eccentric presses (e.g. make Müller-Weingarten), heavy-duty spur and bevel gears with steel/steel components (e.g. gear motors that are not oiltight), slideways, guides and sump lubricated rolling bearings.

Perma Flex M125 Lubricant dispenser

• The automatic lubrication system perma FLEX is available in two convenient sizes (60 cm³ / 125 cm³).
• It can be used for inside or outside applications at temperatures ranging from -20 °C to +60 °C.
• Discharge period setting is flexible and can be adjusted from 1 – 12 months using the dial on top of the lubricator.
• Perma FLEX comes fully assembled and ready-to-use. Simply turn the dial to the desired discharge period and the system is activated.
• The electronically controlled chemical reaction will build up the pressure that is necessary to continually supply the lubrication point with fresh lubricant.

---

Hazard Information (CLP)

Signal word: Warning

Hazard statements (H-codes)

• H319: Causes serious eye irritation.

Precautionary statements (P-codes)

Prevention:

• P264: Wash skin thoroughly after handling.
• P280: Wear eye protection/face protection.

Response:

• P305 + P351 + P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P337 + P313: If eye irritation persists: Get medical advice/attention.

Additional Labelling (EUH-codes)

• EUH208: Contains dibutyl[[bis[(2-ethylhexyl)oxy]phosphinothioyl]thio]succinate. May produce an allergic reaction.

 

Information on product safety (Manufacturer, Contact)

perma-tec GmbH & Co. KG, Hammelburger Str. 21, 97717 Euerdorf, Deutschland, +49 9704 609-0, [email protected]